BLLED Firmware

This guide shows the installation process of the BLLED firmware.

This Firmware is expirimental and can have bugs / unexpected behaviour, if you experience any of this please report it in our discord.

Before you get too excited and wire everything up, let's take a step back and install the latest firmware

if you have wired up the board disconnect all the wires and bring it to your computer.
Connect a USB cable to both your computer and the device. If you don't already have it installed, make sure to install the CH340 drivers.
Open this page via Chrome or Edge browser and click on the connect button below
Click on the first device that shows up as USB Serial then press connect.
Then Click on Install BLController

6. Make sure Erase device has been checked and click next.

7. Click Install and wait for the firmware to be installed. once installed close the promp and refresh this page

8. Next head over to the Configuration Setup page Here: https://dutchdevelop.com/blled-configuration-setup
And follow the steps on this page

9. Once thats done you've successfully setup your blledcontroller

Alternatively you can try this expirimental firmware if you have Rev1 [esp8266] version of the blled controller